**Prerequisite –** Introduction to Ethernet, Basics of CSMA/ CD

**Carrier sense multiple access with collision detection (CSMA/CD) –**

The CSMA method does not tell us what to do in case there is a collision. Carrier sense multiple access with collision detection (CSMA/CD) adds on to the CSMA algorithm to deal with the collision. In CSMA/CD, the size of a frame must be large enough so that collision can be detected by sender while sending the frame. So, the frame transmission delay must be at least *two times* the maximum propagation delay.

Assume some station transmitted data packet and successfully get to the destination but it just the *Best Case*, so we have to take *Worst Case* scenario in which there will be contention slots. Contention slots are those slot which are not able to transmit their journey due to the collision. Suppose A station transmitted data but collide and worst case time wasted is **2Tp** and then some station B found out a way to transmit the data so it took (As shown in Figure)

Tp ( propagation delay) + Tt(transmission time)

Now we don’t know how many contention slot, so we consider the worst case to be of **n** contention slots.

Efficiency = Tt / ( C*2*Tp + Tt + Tp) Tt ? transmission time Tp ? propagation time C ? number of collision

In CSMA/CD, for success, only 1 station should transmit while others shouldn’t. Let p be the probability to transmit data successfully.

P(success) = nC1 * p * (1-p)^{n-1}(by using Binomial distribution)

For max P(success), differentiate with respect to p and equate to zero (to get maxima and minima).

We get P(max) = 1/e

Number of times we need to try before getting 1st success

1/P(MAX) = 1/(1/e) = e

Here number of times we need to try (C) = e.

Put a = Tt/Tp and divide by T in Efficiency = Tt / (C* 2 * Tp + Tt + Tp)

We get,

Efficiency = 1/(e*2a + 1 + a) a = Tp/Tt e = 2.72 NowEfficiency= 1/( 1 + 6.44a)

**Further Analysis of Efficiency : **

Efficiency = 1/ (1 + 6.44a) = 1/ {1 + 6.44(Tp/Tt)} = 1/ {1 + 6.44((distance/speed)(Bandwidth/packet length))}

From this derivation, we can conclude many relations :

- If distance increases, efficiency of CSMA decreases.
- CSMA is not suitable for long distance networks like WAN; but works optimally for LAN.
- If length of packet is bigger, the efficiency of CSMA also increases; but maximum limit for length is 1500 Bytes.
- Transmission Time >= 2*Propagation Time

**GATE CS Corner Questions**

Practicing the following questions will help you test your knowledge. All questions have been asked in GATE in previous years or in GATE Mock Tests. It is highly recommended that you practice them.

- GATE CS 2003, Question 90
- GATE CS 2015 (Set 3), Question 65
- GATE IT 2005, Question 27
- GATE IT 2005, Question 71
- GATE CS 2016 (Set 2), Question 63
- GATE IT 2008, Question 63

**Reference –**

https://www.youtube.com/watch?v=74zlRH-bj2c

This article is contributed by **Akash Sharan**. If you like GeeksforGeeks and would like to contribute, you can also write an article using contribute.geeksforgeeks.org or mail your article to contribute@geeksforgeeks.org. See your article appearing on the GeeksforGeeks main page and help other Geeks.

Please write comments if you find anything incorrect, or you want to share more information about the topic discussed above.

Attention reader! Don’t stop learning now. Get hold of all the important CS Theory concepts for SDE interviews with the CS Theory Course at a student-friendly price and become industry ready.

## Recommended Posts:

- Efficiency Of Token Ring
- Efficiency of Stop and Wait Protocol
- Difference between Time Sharing OS and Multiprogramming OS
- Difference between UDP and RTP
- Difference between XSS and CSRF
- Address Binding and its Types
- Performance of paging
- SDN Controllers (Ryu and ODL)
- Difference between Texting and Messaging
- Cyber Security - Attacking through Command and Control
- Payload in Computer Networks
- User mode and Kernel mode Switching
- Fiber Optics Broadband Connection
- Difference between Broadband and DSL