Operators are used to perform different kinds of operations on operands. Which operator is performed first in an expression with more than one operators with different precedence is determined by operator precedence. when two operators of the same precedence appear in expression associativity is used. For example, ‘*’ and ‘/’ have the same precedence, so the expression “100 / 10 * 10” is worked as “(100 / 10) * 10”.
10 + 20 * 30 is calculated as 10 + (20 * 30) and not as (10 + 20) * 30
In below table operators with the highest precedence appear at the top of the table and operators with the lowest precedence appear at the bottom.
|[ ] [ ]=||Element reference, element set|
|!, ~, +||Boolean NOT, bitwise complement, unary plus|
|*, /, %||Multiplication, division, modulo (remainder)|
|+, –||Addition (or concatenation), subtraction|
|< <, > >||Bitwise shift-left (or append), bitwise shift-right|
||, ^||Bitwise OR, bitwise XOR|
|>, >=, <, <=||Ordering|
|<=>, ==, ===, !=, =~, !~||Equality, pattern matching, comparison|
|| |||Logical OR|
|.., …=||Range creation and Boolean flip-flops|
|=, +=, -=, etc.||Assignment|
|defined?||Test variable definition and type|
|not||Boolean NOT (low precedence)|
|or, and||Boolean OR, Boolean AND|
|modifier-if, modifier-unless, modifier-while, modifier-until||Conditional and loop modifiers|
Below is the example of operator Precedence.
Value of a + b * c / d is : 50
In above example, multiply and divide have equal precedence. so it will work like 20 + (10 * 15) /5. firstly multiply perform than divide after that addition because addition has low precedence.
- Operator Overloading in Ruby
- Ruby | BigDecimal <= value
- Ruby | BigDecimal >= value
- Ruby | BigDecimal + value
- Ruby | BigDecimal <=> value
- Ruby | BigDecimal == value
- Ruby Directories
- Ruby | BigDecimal % value
- Ruby | BigDecimal * value
- Recursion in Ruby
- Ruby | BigDecimal ** value
- Or Keyword in Ruby
- Ruby | BigDecimal +@ value
- Ruby | BigDecimal > value
- Ruby | BigDecimal / value
- Ruby | BigDecimal -@ value
- Ruby | BigDecimal - value
- Ruby | BigDecimal < value
- Ruby Literals
- Ruby | Set add? function
If you like GeeksforGeeks and would like to contribute, you can also write an article using contribute.geeksforgeeks.org or mail your article to firstname.lastname@example.org. See your article appearing on the GeeksforGeeks main page and help other Geeks.
Please Improve this article if you find anything incorrect by clicking on the "Improve Article" button below.