Open In App
Related Articles

GATE | GATE CS 1997 | Question 51

Improve
Improve
Improve
Like Article
Like
Save Article
Save
Report issue
Report
A D flip-flop is to be connected to an 8085 microprocessor chip as a 1-bit output port with a port address of FF hex. Data bit D3 should be involved in the data transfer from CPU to the flip-flop. The flip-flop should be cleared on power ON.
  • a. Using only one NAND gate (fan in of 10), one NOT gate and one D flip-flop. Draw the required interface logic circuit (only the relevant signals should be shown).
  • b. Write a program to generate a square wave on the output of the flip-flop. ON and OFF periods of the square wave should be 7 bus cycles each.


Answer:

Explanation:

Quiz of this Question

Last Updated : 20 Nov, 2018
Like Article
Save Article
Previous
Next
Share your thoughts in the comments
Similar Reads