Problem: We are given two decimal numbers we have to find the GCD of two numbers and print the GCD in decimal format.
Refer for finding GCD of two numbers.
Examples:
Input: d1 = 16, d2 = 24 Output: GCD = 8 Input: d1 = 12, d2 = 18 Output: GCD = 6
Explanation:
- Load value d1 in ax and d2 in bx
- Call the gcd function
- If value in bx is zero
- Then set the value of gcd ( CX ) as ax
- Else set the value of ax as bx and value of bx as ax % bx
- Call the gcd function recursively
- Load the value of cx into ax
- Call the print function to print the gcd of two numbers
Program:
.MODEL SMALL .STACK 100H
.DATA
d1 dw 16 d2 dw 24
.CODE
MAIN PROC FAR
MOV AX,
@DATA
MOV DS,
AX
;initialize ax and bx mov bx,
d2
mov ax,
d1
;find gcd of two numbers call gcd
;load the gcd in ax mov ax,
cx
;print the value CALL PRINT
;interrupt to exit
MOV AH,
4CH INT 21H
MAIN ENDP
GCD PROC
; if
bx is 0 cmp bx, 0 jne continue
;then gcd is ax mov cx,
ax
ret
continue :
; else gcd(b, a % b)
xor dx,
dx
;divide ax by bx div bx
;initialize ax as bx mov ax,
bx
;and bx as ax % bx mov bx,
dx
;recursively call gcd call GCD
ret
GCD ENDP
PRINT PROC
;initialize count mov cx,
0 mov dx, 0 label1:
; if
ax is zero
cmp ax,
0 je print1
;initialize bx to 10 mov bx, 10 ;extract the last digit div bx
;push it in the stack push dx
;increment the count inc cx
;set dx to 0 xor dx,
dx
jmp label1
print1:
;check if count
;is greater than zero cmp cx,
0 je exit
;pop the top of stack pop dx
;add 48 so that it ;represents the ASCII ;value of digits add dx,
48
;interrupt to print a ;character mov ah,
02h int 21h
;decrease the count dec cx
jmp print1
exit : ret
PRINT ENDP
END MAIN
|
Output:
8
Note: The program cannot be run on an online editor, please use MASM to run the program and use dos box to run MASM, you might use any 8086 emulator to run the program